In case of any difficulties with the Radio Link connection, it is advised to change the radio frequency channel on which the PowerEgg performs communication between a drone and base station. 


NOTE: It is important to perform this operation at ground before unlock/flying drone, NEVER do it when the drone is flying in air.

In order to do so please follow the steps described below: 


Start by connecting your PowerEgg with your mobile device and pressing the little map in the left lower corner followed by the settings button in the upper right corner (3 vertical lines). 


Then, go to the general SETTING (right lower corner) and choose the transmition tile. 



You will open "LINK SETTINGS". In order to change your current channel, select the first option of "SELECT CHANNEL" 

with the list of available channels. 


Choose any selected channel. 

You should be able to observe the notification that the settings were successfully changed. \


The channel change MUST be done at the ground before unlock/flying drone.

NEVER do it when the drone is in the air. 


In case of any further questions, our Support Center remains at your disposal.